Table 33: Port And Encapsulation Values - Alcatel-Lucent 7705 Service Manual

VLL Services Command Reference
qtag1 — specifies the encapsulation value used to identify the SAP on the port or sub-port. If this
Port Type Encap-Type
Ethernet Null
Ethernet Dot1q
create — keyword used to create a SAP instance. The create keyword requirement can be
mac
Syntax [no] mac ieee-address
Context config>service>ipipe>sap
Description This command assigns a specific MAC address to an Ipipe Ethernet SAP.
The no form of this command returns the MAC address of the SAP to the default value.
Default The default is the physical MAC address associated with the Ethernet interface where the SAP is
configured.
Parameters
ieee-address — specifies the 48-bit MAC address in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
Page 246
bundle-id:
bundle-id value range:
For example:
*A:ALU-12>config# port bundle-ppp-5/1.1
*A:ALU-12>config>port# multilink-bundle
parameter is not specificially defined, the default value is 0.
Values qtag1:
The values depend on the encapsulation type configured for the interface.
allowed values for the port and encapsulation types.

Table 33: Port and Encapsulation Values

Allowed Values
—
0 to 4094
enabled/disabled in the environment>create context.
where aa, bb, cc, dd, ee, and ff are hexadecimal numbers
bundle-type-slot-id/mda-slot.bundle-num
1 to 10
0 to 4094
Comments
The SAP is identified by the port.
The SAP is identified by the 802.1Q tag on the port. Note that a
0 qtag1 value also accepts untagged packets on the dot1q port.
7705 SAR OS Services Guide
Table 33
describes the