Alcatel-Lucent 7705 Service Manual page 238

VLL Services Command Reference
VLL Global Commands
apipe
Syntax apipe service-id [customer customer-id] [create] [vpn vpn-id] [vc-type {atm-vcc | atm-
vpc}] [vc-switching]
no apipe service-id
Context config>service
Description This command configures a point-to-point ATM service. The Apipe service provides a point-to-point
L2 VPN connection to a local or remote SAP. An Apipe can connect an ATM endpoint locally (in the
same 7705 SAR) or over a PSN to a remote endpoint of the same type.
Parameters service-id — uniquely identifies a service in the service domain. This ID must be unique to this
create — keyword used to create an Apipe. The create keyword requirement can be enabled/disabled
customer-id — specifies the customer ID number to be associated with the service. This parameter is
vpn-id — specifies the VPN ID number that allows you to identify virtual private networks (VPNs) by
vc-type — specifies a 15-bit value that defines the type of the VC signaled to the peer. Its values are
vc-switching — specifies that pseudowire switching signaling is used for the spoke SDPs configured
Page 238
service and may not be used for any other service of any type. The service-id must be the same
number used for every 7705 SAR on which this service is defined.
Values
1 to 2147483647
in the environment>create context
required on service creation and optional for service editing or deleting.
Values 1 to 2147483647
a VPN identification number. If this parameter is not specified, the VPN ID uses the same service
ID number.
Values
1 to 2147483647
Default
null (0)
defined in draft-ietf-pwe3-iana-allocation and it defines both the signaled VC type as well as the
resulting datapath encapsulation over the Apipe.
Values atm-vcc, atm-vpc
Default atm-vcc
for this service
7705 SAR OS Services Guide