Alcatel-Lucent 7705 Service Manual page 450

VPRN Services Command Reference
customer-id — an existing customer identification number to be associated with the service. This
auto-bind
Syntax auto-bind {ldp | gre}
no auto-bind
Context config>service>vprn
Description
This command specifies the type of automatic binding for the SDP assigned to this service. When
auto-bind is used, it is not required that a spoke-SDP be configured for the service.
Default no auto-bind
Parameters ldp — specifies LDP as the automatic binding for the SDP assigned to the service
gre — specifies GRE as the automatic binding for the SDP assigned to the service
maximum-routes
Syntax maximum-routes number [log-only] [threshold percent]
no maximum-routes
Context config>service>vprn
Description This command specifies the maximum number of routes that can be held within a VPN routing/
forwarding (VRF) context.
The VPRN service ID must be in a shutdown state in order to modify maximum-routes command
parameters.
If the log-only parameter is not specified and the maximum-routes value is set to a value below the
existing number of routes in a VRF, then the exceeding (extra) routes will not be added to the VRF.
The maximum route threshold can dynamically change to increase the number of supported routes
even when the maximum has already been reached. Protocols will resubmit the routes that were
initially rejected.
The no form of the command disables any limit on the number of routes within a VRF context. Issue
the no form of the command only when the VPRN instance is shut down.
Default
no maximum-routes (0 or disabled)
Parameters number — an integer that specifies the maximum number of routes to be held in a VRF context
Page 450
parameter is required during service creation and is optional for service editing or deleting.
Values
1 to 2147483647
Values 1 to 2147483647
7705 SAR OS Services Guide