Alcatel-Lucent 7705 Service Manual page 459

bfd-enable — associates the state of the static route to a BFD session between the local system and
cpe-ip-address — the IP address of the target CPE device. ICMP pings will be sent to this target IP
seconds — the interval between ICMP pings to the target IP address
count — the number of consecutive ping-replies that must be missed in order to declare the CPE
log — enables the logging of transitions between active and inactive routes based on the CPE
black-hole — specifies a black hole route, meaning that if the destination address on a packet
type
Syntax type hub
no type
Context config>service>vprn
Description
This command designates the type of VPRN instance being configured for hub and spoke topologies.
The no form of the command resets to the default of a fully meshed VPRN.
Default no type
7705 SAR OS Services Guide
The ip-address configured here can be either on the network side or the access side on this node.
This address must be associated with a network directly connected to a network configured on
this node.
Values ip-int-name
ip-address
the configured next hop. This keyword is only available when the next-hop keyword is used.
address. This parameter must be configured to enable the CPE connectivity feature for the
associated static route. The cpe-ip-address cannot be in the same subnet as the static route subnet
itself to avoid possible circular references. This option is mutually exclusive with BFD support
on a given static route.
Default
no cpe-check enabled
Values a.b.c.d
Values 1 to 255 seconds
Default 1 second
down and to deactivate the associated static route
Values
1 to 255
Default
3
connectivity check. Events should be sent to the system log, syslog and SNMP traps.
matches this static route, it will be silently discarded.
The black-hole and next-hop keywords are mutually exclusive. If an identical command is
entered, with the exception of the next-hop parameters, the static route is replaced with the new
command, and unless specified, the respective defaults for preference and metric are applied.
32 chars max
a.b.c.d
VPRN Services
Page 459