Alcatel-Lucent 7705 Service Manual page 457

static-route
Syntax [no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [enable | disable] {next-hop ip-int-name | ip-address}
[bfd-enable | {cpe-check cpe-ip-address [interval seconds] [drop-count count] [log]}]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [enable | disable] [cpe-check cpe-ip-address [interval seconds]
[drop-count count] [log]]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [enable | disable] black-hole
Context config>service>vprn
Description This command creates static route entries within the associated router instance. When configuring a
static route, either next-hop or black-hole must be configured.
The no form of the command deletes the static route entry. If a static route needs to be removed when
multiple static routes exist to the same destination, then enter as many parameters as necessary to
uniquely identify that static route.
If a CPE connectivity check target address is already being used as the target address in a different
static route, then cpe-check parameters must match. If they do not match, the new configuration
command will be rejected.
If a static-route command is issued with no cpe-check target but the destination prefix/netmask and
next-hop matches a static route that did have an associated cpe-check, then the cpe-check test will be
removed from the associated static route.
Default no static-route
Parameters
ip-prefix — the destination address of the aggregate route in dotted-decimal notation
prefix-length — the prefix length expressed as a decimal number
netmask — the subnet mask in dotted-decimal notation
7705 SAR OS Services Guide
Values
a.b.c.d (host bits must be 0)
Values 0 to 32
Values a.b.c.d (network bits all 1 and host bits all 0)
VPRN Services
Page 457