Alcatel-Lucent 7705 Service Manual page 129

7705 SAR OS Services Guide
Table 14: Show Service SDP Output Fields (Continued)
Label
Opr
Oper State
Deliver
Delivery
Flags
Signal
Signaling
Metric
Last Status Change
Last Mgmt Change
Adv. MTU Over
VLAN VC Etype
Number of SDPs
Keepalive Information:
Hello Time
Hello Msg Len
Hello Timeout
Unmatched Replies
Max Drop Count
Hold Down Time
TX Hello Msgs
Description
Specifies the operating state of the SDP
Specifies the type of delivery used by the SDP: MPLS, GRE, or IP
Specifies all the conditions that affect the operating status of this SDP
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP
Specifies the value used as a tie-breaker by the tunnel table manager to
select a route
Specifies the time of the most recent operating status change to this
SDP
Specifies the time of the most recent management-initiated change to
this SDP
Specifies the state of the advertised VC-type MTU override command
Specifies the VLAN VC EtherType for the SDP
Specifies the total number of SDPs displayed according to the criteria
specified
Specifies how often the SDP Echo Request messages are transmitted on
this SDP
Specifies the length of the SDP Echo Request messages transmitted on
this SDP
Specifies the number of seconds to wait for an SDP echo response
message before declaring a timeout
Specifies the number of SDP unmatched message replies timer expired
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault
Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared
Services Overview
Page 129