Alcatel-Lucent 7705 Service Manual page 312

VLL Services Command Reference
Label
LbNextSequence
LtNextSequence
LtRxUnexplained
ATM SAP Configuration Information
Ingress TD Profile
Egress TD Profile
Alarm Cell
Handling
OAM Termination
CEM SAP Configuration Information
Endpoint Type
Bit-rate
Payload Size
Jitter Buffer
Use RTP Header
CAS Framing
Effective PVDT
Cfg Alarm
Alarm Status
Page 312
Table 40: Service-ID SAP Output Fields (Continued)
Description
Displays the sequence number of the next LB transmission
Displays the sequence number of the next Linktrace (LT) message
transmitted
Displays the number of the unexplained Linktrace (LT) messages
The profile ID of the traffic descriptor applied to the ingress SAP
The profile ID of the traffic descriptor applied to the egress SAP
Indicates that OAM cells are being processed
Indicates whether this SAP is an OAM termination point
Specifies the type of endpoint
Specifies the number of DS0s or timeslots in the channel group
Specifies the number of octets contained in the payload of a TDM
PW packet when the packet is transmitted
Specifies the size of the receive jitter buffer, expressed in
milliseconds
Specifies whether RTP headers are used in CES packets (Yes or No)
Specifies the type of CAS framing
Displays the peak-to-peak packet delay variation (PDV) used by the
circuit emulation service.
Since the operating system may adjust the jitter buffer setting in
order to ensure no packet loss, the configured jitter buffer value may
not be the value used by the system. The effective PVDT provides an
indication that the PVD has been adjusted by the operating system
Jitter Buffer on page 154
(see
Specifies the alarms that have alarm reporting enabled
Indicates the current alarm state (for example, stray, malformed,
packet loss, overrun, underrun, remote packet loss, remote fault, or
remote RDI)
)
7705 SAR OS Services Guide