Alcatel-Lucent 7705 Service Manual page 311

Label
LowestDefectPri
HighestDefect
Defect Flags
Mac Address
CcmLtmPriority
CcmTx
CcmSequenceErr
DmrRepliesTx
LmrRepliesTx
Dual-Loss Test
Dual-Loss Thresh
Eth-Ais
Eth-Ais Rx Ais
Eth-Ais Tx
Priorit*
Eth-Ais Rx Interv*
Eth-Ais Tx
Interva*
Eth-Ais Tx Counte*
Eth-Ais Tx Levels
Eth-Tst
LbRxReply
LbRxBadOrder
LbRxBadMsdu
LbTxReply
7705 SAR OS Services Guide
Table 40: Service-ID SAP Output Fields (Continued)
Description
Displays a configured value that defects are evaluated against
Displays the highest defect
Indicates the defect flags
Displays the MAC address (the MAC address for a spoke SDP is the
system MAC address; for a SAP, it is the port MAC address)
Displays the priority of the CCM Linktrace Message (LTM)
Displays the number of CCM transmissions
Displays the number of CCM sequence errors
Displays the number of delay measurement replies transmitted
Displays the number of loss measurement replies transmitted
Displays the status of the dual-ended loss measurement test (enabled
or disabled)
Displays the frame error threshold beyond which an alarm will be
raised. The threshold is expressed as a percentage.
Displays the status of the ETH-AIS test (enabled or disabled)
Indicates whether any ETH-AIS messages have been received
Displays the priority value of a transmitted ETH-AIS frame
Indicates the interval of a received ETH-AIS frame
Displays the interval of a transmitted ETH-AIS frame
Displays the number of ETH-AIS frames that have been sent
Indicates the MD level of transmitted ETH-AIS frames
Indicates the status of the ETH-Test (enabled or disabled)
Displays the number of received loopback (LB) replies
Displays the number of LB replies that have been received in the
wrong order
Displays the number of LB replies that have been received with the
wrong destination MAC address (MSDU = MAC Service Data Unit)
Displays the number of LBRs (loopback replies) transmitted out this
MEP
VLL Services
Page 311