Alcatel-Lucent 7705 Service Manual page 116

Global Service Command Reference
Default The default path-mtu defined on the system for the type of SDP is used.
Parameters bytes — specifies the number of bytes in the path MTU
signaling
Syntax signaling {off | tldp}
Context config>service>sdp
Description This command specifies the signaling protocol used to obtain the ingress and egress labels in frames
transmitted and received on the SDP. When signaling is off, then labels are manually configured
when the SDP is bound to a service. The signaling value can only be changed while the administrative
status of the SDP is down.
The no form of this command is not applicable. To modify the signaling configuration, the SDP must
be administratively shut down and then the signaling parameter can be modified and re-enabled.
Default tldp
Parameters off — ingress and egress signal auto-labeling is not enabled. If this parameter is selected, then each
tldp — ingress and egress signaling auto-labeling is enabled
vlan-vc-etype
Syntax vlan-vc-etype 0x0600..0xffff
no vlan-vc-etype [0x0600..0xffff]
Context config>service>sdp
Description This command configures the VLAN VC EtherType. The no form of this command returns the value
to the default. The etype value populates the EtherType field in the Ethernet frame. It is used to
indicate which protocol is being transported in the Ethernet frame. The default value indicates that the
payload is an IEEE 802.1q-tagged frame.
Default no vlan-vc-etype (0x8100)
Parameters 0x0600..0xffff — specifies a valid VLAN etype identifier
Page 116
Values 576 to 9194
service using the specified SDP must manually configure VPN labels. This configuration is
independent of the SDP's transport type, MPLS (LDP).
7705 SAR OS Services Guide