Alcatel-Lucent 7705 Service Manual page 114
Service aggregation router os
Hide thumbs
Also See for 7705:
- Configuration manual (532 pages) ,
- Interface configuration manual (226 pages) ,
- Installation manual (176 pages)
Table of Contents
Advertisement
Global Service Command Reference
Parameters
ip-address — the system address of the far-end 7705 SAR for the SDP
ldp
Syntax
[no] ldp
Context
config>service>sdp
Description
This command enables LDP-signaled LSPs on MPLS-encapsulated SDPs.
In MPLS SDP configurations, either one LSP can be specified or LDP can be enabled. The SDP ldp
and lsp commands are mutually exclusive. If an LSP is specified on an MPLS SDP, then LDP cannot
be enabled on the SDP. To enable LDP on the SDP when an LSP is already specified, the LSP must
be removed from the configuration using the no lsp lsp-name command.
Alternatively, if LDP is already enabled on an MPLS SDP, then an LSP cannot be specified on the
SDP. To specify an LSP on the SDP, LDP must be disabled. The LSP must have already been created
in the config>router>mpls context with a valid far-end IP address.
Default
no ldp (disabled)
lsp
Syntax
[no] lsp lsp-name
Context
config>service>sdp
Description
This command creates an association between an LSP and an MPLS SDP. This command is
implemented only on MPLS-type encapsulated SDPs.
In MPLS SDP configurations, either one LSP can be specified or LDP can be enabled. The SDP ldp
and lsp commands are mutually exclusive. If an LSP is specified on an MPLS SDP, then LDP cannot
be enabled on the SDP. To enable LDP on the SDP when an LSP is already specified, the LSP must
be removed from the configuration using the no lsp lsp-name command.
Alternatively, if LDP is already enabled on an MPLS SDP, then an LSP cannot be specified on the
SDP. To specify an LSP on the SDP, LDP must be disabled. The LSP must have already been created
in the config>router>mpls context with a valid far-end IP address. Refer to the 7705 SAR OS MPLS
Guide for CLI syntax and command usage.
If no LSP is associated with an MPLS SDP, the SDP cannot enter the operationally up state. The SDP
can be administratively enabled (no shutdown) with no LSP associations. The lsp-name may be shut
down, causing the association with the SDP to be operationally down (the LSP will not be used by the
SDP).
LSP SDPs also require that the TLDP signaling be specified and that the SDP keepalive parameter be
enabled and not timed out.
Page 114
Values
a.b.c.d
7705 SAR OS Services Guide
Advertisement
Table of Contents
Troubleshooting
