Configuring Epipe Sap Parameters - Alcatel-Lucent 7705 Service Manual

Configuring VLL Components

Configuring Epipe SAP Parameters

The
distributed Epipe consists of two SAPs on different nodes. A local Epipe consists of both
SAPs on the same 7705 SAR. To configure a distributed Epipe service, you must configure
service entities on the originating and far-end nodes.
Use the following CLI syntax to create distributed Epipe SAPs. For ingress and egress
configuration information, see
217. For SAP ETH-CFM configuration information, see
(802.1ag and Y.1731) on page
CLI Syntax: config>service# epipe service-id [customer customer-id]
[create] [vc-switching]
Example:
Page 208
supports distributed Epipe service and local (SAP-to-SAP) Epipe service. A
7705 SAR
sap sap-id [create]
accounting-policy policy-id
collect-stats
description description-string
no shutdown
egress
eth-cfm
ingress
ALU-1>epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe
service to east coast"
config>service>epipe# sap 1/1/3:21 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# qos 555
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# egress
config>service>epipe>sap>egress# qos 627
config>service>epipe>sap>egress# exit
config>service>epipe>sap# no shutdown
config>service>epipe>sap# exit
config>service>epipe#
ALU-2>config>service# epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe
service to west coast"
config>service>epipe# sap 1/1/4:550 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 654
config>service>epipe>sap>ingress# exit
Configuring Ingress and Egress SAP Parameters on page
95.
qos policy-id
filter [ip ip-filter-id]
qos policy-id
7705 SAR OS Services Guide
Configuring ETH-CFM Parameters