Alcatel-Lucent 7705 Service Manual page 123

bridge-identifier
Syntax [no] bridge-identifier bridge-id
Context config>eth-cfm>domain>association
Description This command configures the VLL service ID for the domain association. The bridge-id should be
configured to match the service-id of the VLL service where MEPs for this association will be
created. For example, for an Epipe with service-id 2, set the bridge-id to 2. Note that there is no
verification that the service with a matching service-id exists.
Parameters bridge-id — specifies the bridge ID for the domain association
vlan
Syntax vlan vlan-id
no vlan
Context config>eth-cfm>domain>association>bridge-identifier
Description This command configures the bridge-identifier primary VLAN ID. Note that it is informational only,
and no verification is done to ensure that MEPs on this association are on the configured VLAN.
Parameters vlan-id — specifies a VLAN ID monitored by MA
ccm-interval
Syntax ccm-interval {10ms | 100ms | 1 | 10 | 60 | 600}
no ccm-interval
Context config>eth-cfm>domain>association
Description This command configures the CCM transmission interval for all MEPs in the association, in
milliseconds and seconds.
The no form of the command reverts to the default value.
Default
10 s
7705 SAR OS Services Guide
Values 1 to 2147483647
Values 0 to 4094
Services Overview
Page 123