Alcatel-Lucent 7705 Service Manual page 247

mac-refresh
Syntax mac-refresh refresh-interval
no mac-refresh
Context config>service>ipipe>sap
Description This command specifies the interval between ARP requests sent on an Ipipe Ethernet SAP. When the
SAP is first enabled, an ARP request will be sent to the attached CE device and the received MAC
address will be used in addressing unicast traffic to the CE. Although this MAC address will not
expire while the Ipipe SAP is enabled and operational, it is verified by sending periodic ARP requests
at the specified interval.
The no form of this command restores mac-refresh to the default value.
Default
14400
Parameters
refresh-interval — specifies the interval, in seconds, between ARP requests sent on an Ipipe Ethernet
ipcp
Syntax [no] ipcp
Context config>service>ipipe>sap
Description
This command enables the context to configure IPCP. Within this context, IPCP extensions can be
configured to define the remote IP address and DNS IP address to be signaled via IPCP on the
associated PPP interface.
This command is only applicable if the associated SAP is a PPP/MLPPP interface.
assign-peer-ce-addr
Syntax [no] assign-peer-ce-addr
Context config>service>ipipe>sap>ipcp
Description This command assigns the IP address, defined by the config>service>ipipe>sap>ce-address
command, to the far end of the associated PPP/MLPPP link via IPCP extensions. This command is
only applicable if the associated SAP or port is a PPP/MLPPP interface with an IPCP encapsulation.
Default
no assign-peer-ce-addr
7705 SAR OS Services Guide
SAP
Values 0 to 65535
VLL Services
Page 247