Table of Contents
Advertisement
Timing
Marks
Push
Loosen
1
5
9
10
6
2
AVENSIS REPAIR MANUAL (RM1018E)
ENGINE MECHANICAL
(b)
If not, turn the crankshaft 1 revolution (360Y) and align the
marks as above.
Timing
Marks
A77345
13.
(a)
NOTICE:
Do not turn the crankshaft.
A77286
14.
Hold
(a)
NOTICE:
Be careful not to damage the cylinder head and valve lifter
with the wrench.
A77412
(b)
(c)
7
3
8
4
A77294
(d)
(e)
(f)
A52473
http://vnx.su
–
CAMSHAFT (1AZ–FSE)
Check that each timing mark of the camshaft timing gears
is aligned with each timing mark located on the No. 1 and
No. 2 bearing caps as shown in the illustration.
REMOVE CHAIN TENSIONER ASSY NO.1
Remove the 2 nuts, the chain tensioner and a gasket.
REMOVE NO.2 CAMSHAFT
Hold the No. 2 camshaft with a wrench on the hexagonal
lobe, and loosen the camshaft timing gear set bolt.
Using several steps, loosen and remove the 10 camshaft
bearing cap bolts uniformly in the sequence shown in the
illustration.
Remove the 5 camshaft bearing caps.
Raising the No. 2 camshaft, remove the set bolt.
Remove the camshaft timing gear from the No. 2 cam-
shaft with with the timing chain wrapped.
Remove the camshaft timing gear from the timing chain.
14–241
Advertisement
Table of Contents
