Saving Settings To An Operator Panel - Siemens SINAMICS G120 Operating Instructions Manual

Low voltage inverters built-in units with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Saving settings to an operator panel

You can transfer the inverter settings to the Operator Panel BOP‑2 or vice versa, the data from

the BOP‑2 to the inverter.

Precondition

The inverter power supply has been switched on.

Inverter → BOP-2

You have backed up the settings to the BOP-2.

BOP-2 → inverter

4. Switch off the inverter power supply.

Converter with the CU250S-2 Control Units

Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG

1. In the "OPTIONS" menu, select "TO BOP".

2. Start data transfer with OK.

3. Wait until the inverter has backed up the settings to the BOP‑2.

1. In the "OPTIONS" menu, select "FROM BOP".

2. Start data transfer with OK.

3. Wait until the inverter has written the settings to the memory card.

Saving the settings and series commissioning

7.3 Saving settings to an operator panel