Speed Limitation - Siemens SINAMICS G120 Operating Instructions Manual

Low voltage inverters built-in units with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Speed limitation

The maximum speed limits the speed setpoint range for both directions of rotation.

The converter generates a message (fault or alarm) when the maximum speed is exceeded.

If you must limit the speed depending on the direction of rotation, then you can define speed

limits for each direction.

Converter with the CU250S-2 Control Units

Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG

Parameters for the speed limitation

Maximum speed (factory setting: 1500 rpm)

Speed limit, positive direction of rotation (factory setting: 210,000 rpm)

CI: Speed limit, positive direction of rotation (factory setting: 1083)

Speed limit, negative direction of rotation (factory setting: -210,000 rpm)

CI: Speed limit, negative direction of rotation (factory setting: 1086)

Advanced commissioning

6.19 Setpoint calculation