Connecting The Interfaces For The Inverter Control - Siemens SINAMICS G120 Operating Instructions Manual

Low voltage inverters built-in units with cu250s-2 control units and encoder evaluation

Hide thumbs Also See for SINAMICS G120:

Table of Contents

Connecting the interfaces for the inverter control

The Power Module has a holder for the Control Unit and a release mechanism.

There are different release mechanisms depending on the particular Power Module.

Inserting the Control Unit

1. Place the two catches of the Control Unit in the matching grooves of the Power Module.

2. Press the Control Unit onto the Power Module until you hear that it latches.

The Control Unit is plugged onto the Power Module.

Removing the Control Unit

Remove the Control Unit from the Power Module by pressing the release mechanism.

Converter with the CU250S-2 Control Units

Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG

4.5 Connecting the interfaces for the inverter control