Siemens SINAMICS G120 Operating Instructions Manual page 125

Connecting a combi encoder
Combi encoders are a combination of SSI encoder with HTL encoder in one enclosure. You
require a Y encoder cable to connect a combi encoder to the inverter.
Figure 4-25
The matching Y encoder cable can be ordered from the KnorrTec company.
Article No. 10051910
Additional information on installing and configuration a combi encoder is available in the
Internet:
cs/en/en/view/109748046)
SMC and SME Sensor Modules
Table 4-20
Two-pole resolver
Multi-pole resolver
sin/cos encoder 1 V
sin/cos encoder 1 V
and D tracks)
SSI encoders with incremental signals sin/cos 1 V
SSI encoders with TTL/HTL incremental signals
SSI encoder without incremental signals
HTL or TTL encoder
Absolute encoders Endat 2.1
You can find information about prefabricated encoder cables for the Sensor Module in the
Internet:
You can find additional information on installing and connecting the Sensor Modules in the
"SINAMICS S120 Control Units and supplementary system components" manual.
68040800)
Converter with the CU250S-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG
Connecting a combi encoder to a CU250S-2 Control Unit
Connecting and commissioning a combi encoder
Permissible SMC/SME Sensor Modules and encoders that can be connected
pp
without rotor position track (C
pp
Encoder cables (https://support.industry.siemens.com/cs/de/en/view/108441438)
S120 system components
(https://support.industry.siemens.com/
SMC10
✓
✓
pp
(http://support.automation.siemens.com/WW/view/en/
4.6 Installing encoders
SMC20 SMC30 SME20
✓
✓
✓
✓
✓
✓
✓
Installing
SME25
✓
✓
123