Transfer Inverters Connected Via Usb Into The Project - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage inverters
built-in units with cu250s-2 control units and
encoder evaluation
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
5.4.2
Transfer inverters connected via USB into the project
Integrating the inverter into the project
Procedure
1. Switch on the inverter power supply.
2. First insert a USB cable into your PC and then into the inverter.
3. The PC operating system installs the USB driver when you are connecting the inverter and
PC together for the first time.
4. Press the "Accessible nodes" button.
5. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
6. Transfer the inverter into the project using the menu: "Online - Upload device as new station
(hardware and software)".
You have transferred an inverter accessible via the USB interface into your project.
❒
Converter with the CU250S-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E31759476B AG
Commissioning
5.4 Quick commissioning with a PC
135
Advertisement
Table of Contents
