Table of Contents
Advertisement
Configuring Individual WAN Connections
Configuring terminal-server connections
Example of terminal-mode configuration
This example shows how to configure the password and make the Rlogin option available to
dial-in users.
1
2
3
4
5
6
Configuring immediate mode
When dial-in calls are directed immediately to a host, the MAX unit establishes a session
between the remote user's PC and that host via Rlogin, Telnet, or TCP. The following
parameters in Ethernet > Mod Config > TServ Options affect the session the unit establishes:
Parameter
Immed Service
Immed Host
Immed Port
Telnet Host Auth
Example of immediate-mode configuration
To configure immediate Telnet service relying on the Telnet host for authentication:
1
2
3
4
5
4-86
Open Ethernet > Mod Config > TServ Options.
Specify the terminal-server password.
Passwd=tspasswd
Set the Telnet parameter to Yes.
Configure a multiline login prompt.
Ethernet
Mod Config
TServ Options
Login Prompt=Welcome to Ascend Remote Server\Enter your
name:
Prompt Format=Yes
Enable the use of the Rlogin command in terminal mode:
Rlogin=Yes
Exit the profile and, at the exit prompt, select the exit and accept option.
Specifies
A particular type of service for establishing an immediate host
connection for dial-in users. You can specify Telnet, Raw-TCP,
Rlogin, or X25-PAD. For details about X.25, see Chapter 6,
"Configuring X.25."
The hostname or address to which users connect in terminal-server
immediate mode.
A TCP port number to use for the connections.
Whether the MAX unit bypasses terminal-server authentication and
goes right to a Telnet login prompt.
Open Ethernet > Mod Config > TServ Options.
Set the Immed Service parameter to Telnet.
Specify the name or IP address of the Telnet host.
If appropriate, specify the TCP port to use on the Telnet host.
Set the Telnet Host Auth parameter to Yes.
MAX 6000/3000 Network Configuration Guide
Advertisement
Table of Contents
