Siemens 6RA7086-6KS22 Operating Instructions Manual page 644

Parameter list
PNU Description
U961 Processing sequence of function blocks of S00 technology
(2961)
software (2)
*
i001: Number of function block for 101
S00
i002: Number of function block for 102
sequence
etc.
U962 Processing sequence of function blocks of S00 technology
(2962)
software (3)
*
i001: Number of function block for 201
S00
i002: Number of function block for 202
sequence
etc.
U969 Automatic setting and activation of the execution sequence
(2969)
0 Return
*
S00 1 Set standard sequence:
The numbers of the function blocks are entered in ascending
order in Parameters U960, U961 and U962. The parameter is
then automatically set to value 0.
2 Set optimum sequence:
U960, U961, and U962 are set in such a way that as few
deadtimes as possible occur. After that, the parameter is
automatically set to value 0 again.
3 Set standard setting of the sampling times.
U950, U951, and U952 are set to the factory setting.
4 Automatic activation / deactivation:
U950, U951 and U952 are set in such a way that the unwired
function blocks are deselected and the wired function blocks are
selected (activated), if they are not yet selected.
The time slice 10 (sampling time 20 ms) is set for all function
blocks not previously activated, the time slice is left unchanged
for all previously activated function blocks.
11-180
st
place in processing sequence
nd
place in processing
st
place in processing sequence
nd
place in processing
Value range No. indices
[Unit] Factory
Steps setting
Type
Numbers of all Ind: 100
function blocks FS=
Standard
sequence
Type: O2
Numbers of all Ind: 100
function blocks FS=
Standard
sequence
Type: O2
0 to 4 Ind: None
1 FS=0
Type: O2
SIEMENS AG
SIMOREG DC Master Operating Instructions
05.05
See
Change
(Access /
Status)
P052 = 3
P051 = 40
Offline
P052 = 3
P051 = 40
Offline
P052 = 3
P051 = 40
off-line
6RX1700-0AD76