Code Table - Lenze 4800 Manual

Show/Hide Bookmarks
7.9

Code table

How to read the code table:
Column
Code
Name
Lenze
Selection
Info
Code Code Name Name
C000¤ Code set
[C001] Operating mode
[C002] Load parameter
set
C003¤ Save parameter
set
C004¤ Switch-on
display
Abbreviation Meaning
C013 Code C013
l
The parameter value is accepted immediately (ONLINE).
l
C009* Code of the extended code set
l
C001¤ The parameter value of the code will be accepted after pressing SH+PRG.
l
[C002] The parameter value of the code will be accepted after pressing SH+PRG,
but only if the controller is inhibited.
Name of the code
Factory setting of the code
1 {1 %} 99 Minimum value
- Additional, important explanation of the code
Possible settings
Lenze Selection
1
-0- (+PW) Standard code set read only
-1- (+PW) Standard code set
-2- (+PW) Extendend code set
-9- For service only
-11- Code set for automation module
0 Control
-0- Terminals Keypad
-1- Keypad
-2- Terminals LECOM1
-3- LECOM1
-4- Terminals LECOM2 (*)
-5- LECOM2 (*) LECOM2 (*)
-6- LECOM2 (*) Keypad
-7- LECOM2 (*) LECOM1
0 -0- Factory setting
-1- Parameter set 1
-2- Parameter set 2
-3- Parameter set 3
-4- Parameter set 4
1 -1- Parameter set 1
-2- Parameter set 2
-3- Parameter set 3
-4- Parameter set 4
83 0 {1}
{smallest step/unit}
Info
Can only be changed via keypad!
If a password is defined under C094, a If a password is defined under C094, a
change from -0- to -1- or -2- is only
possible after entering this password possible after entering this password
(+ PW):
1 Change C000 acknowledge with 1. Change C000, acknowledge with
PRG
2 P 2. Password setting with
3. Accept with SH + PRG.
Parameter setting With C001 =
-2-, -3-, -4-, -5-, -7-, TRIP must be reset
(C043) via the interface or the terminal.
Keypad
With LECOM2, TRIP reset is also possible
via the control word of the process data
LECOM1
channel.
(*) Fieldbus
Parameter set 1 is automatically loaded
after mains connection. If another
parameter set is selected via terminal, this
parameter set will also be loaded.
999 Code No. for switch-on display: Can only
be changed if C001= -0-, -1-, -6-
Configuration
maximum value
SH + SH
.
d tti ith or .
48XX/49XXSHB0399
7-119