Positioning Drive - Lenze 4800 Manual

Show/Hide Bookmarks
Selection aid
Digital, freely programmable inputs
( Ctrl. inhibit of the automation module
( Diameter calculation enable
( Initial diameter
( Winding or unwinding
( Winding from top or bottom
( Enable speed offset
( Changeover torque from calculated value to maximum value
( Enable tension controller
( Enable I component of the tension controller
( Activate web-break monitoring
Note!
For the winding drive explained above do not only observe the Operating
Instructions 48XX/49XX but also the Operating Instructions "Winding calculator"
(see register H).
15.8.2

Positioning drive

Purpose
Simple positioning tasks can be solved with the positioning drive. In many cases
the PLC can be releaved or will not be necessary at all.
For this, use the 2215 modular box. With this box, the positioning drive can be
individually adapted to many different applications.Variants, such as positioning
drive with terminals, InterBus, Beckhof bus or PROFIBUS are available.
15-20
48XX/49XXSHB0399