Lenze 4800 Manual page 203

Show/Hide Bookmarks
Configuration
7-112
48XX/49XXSHB0399
Acceptance with SH + PRG
The controller accepts the changed parameter only after pressing SH+PRG.
1. Select a code using s or t.
2. Change to the parameter level using PRG.
3. Change a parameter (even while the drive is running) using s or t.
4. Press SH + PRG. ( --ok-- is displayed for approx. 0.5 s)
The controller now works with the new parameter.
Code level
Code Parameter
C 0 8 3 0 . 0 0
F I E L D C U R R E N T
Code Parameter
C 0 8 3 1 . 2 0
F I E L D C U R R E N T
Acceptance with SH + PRG when the controller is inhibited
The controller only accepts the changed parameter when the controller is inhibited
and after pressing SH + PRG.
1. Select a code using s or t
2. Change to the parameter level using PRG.
3. Change a parameter (even if the drive is running) using s or t .
4. Press STP to inhibit the controller.
5. Press SH + PRG. ( --ok-- is displayed for approx. 0.5 s)
6. Press SH + STP to enable the controller again
The controller now works with the new parameter.
Code level
Code Parameter
C 0 0 5 - 1 1 -
C o n f i g u r a t i o n
Code Parameter
C 0 0 5 - 1 0 . -
C o n f i g u r a t i o n
Parameter level
Unit Code
PRG
A C
F I E L D
Change a parameter
with s or t
Unit Code
SH + PRG
C
A
F I E L D
Parameter level
Unit Code
PRG
C 0 0 5
S P E E D
Change a parameter
with s or t
Unit Code
STP
2. SH + PRG
C 0 0 5
S P E E D
Parameter Unit
0 8 3 0 . 0 0 A
C U R R E N T
Parameter Unit
0 8 3 1 . 2 0 A
C U R R E N T
Parameter Unit
- 1 1 -
C T R L T A C H O
Parameter Unit
- 1 0 -
C T R L A R M A T