Lenze 4800 Manual page 112

Show/Hide Bookmarks
Code Code Name Name
C029¤ Automatic
adjustment
for C025
Possible settings
Lenze Selection
100%
C007 = -5-, -6-, -9-, -20-:
Automatic adjustment for analog inputs
-100 % {0.1 %}
C025 = -2- and tacho at X1/3, X1/4 or
C025 = -5- and actual value from armature voltage
feedback:
n adjustment
act
0 rpm {1rpm}
C025 = -10-, -11-:
Adjustment of the digital frequency inputs X5, X9
-100.0 % {0.1 %}
C025 = -12-:
Adjustment of the resolver
-100.0 % {0.1 %}
Configuration
Info
This applies to all configurations:
If an automatic adjustment is not possible,
the previous value will be maintained.
--ok-- will not be displayed.
1.Inhibit controller.
2.Set setpoint at the terminal selected.
100.0%
3.Enter the required values.
4.C027 displays the calculated gain
factor.
Adjustment during operation:
1.Display of actual speed.
2.Measure real speed with hand tacho.
3.Enter real speed.
5000rpm
4.Drive accelerates to this speed.
5.C027 displays the calculated gain
factor.
Automatic adjustment only possible, if X5
or X9 are not selected as acutal speed
inputs:
100.0%
1.Display of actual output value.
2.Enter required output value.
3.C027 displays the calculated gain
factor.
Automatic adjustment is only possible, if
the resolver is not used as speed
feedback system:
100.0%
1.Display of actual output value.
2.Enter required output value.
3.C027 displays the calculated gain
factor.
48XX/49XXSHB0399
7-21