3
Short setup of the technology application
3.5
Step 4: create the positioning program (sequence table)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.5
Step 4: create the positioning program (sequence table)
The sequence table is parameterised in the parameterisation dialog for the L_Sequencer_1 FB.
Note!
In the default setting, the sequence table already contains a small "positioning
program", which rotates the axis first by 360° in clockwise direction and then by 360° in
counter-clockwise direction.
The parameterisation dialog is divided into four main areas:
Main area
Sequence table (sequencer)
Selection of action type
Comment on the action
Action parameters
Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05
Info
The sequence table consists of 100 fields which can be filled with actions.
In this area, the different action types are provided for selection, by means of
which the sequence table can be filled.
Optionally, a comment on the action selected can be entered here.
In this area, the parameters for the action selected are set.
23