Lenze 4800 Manual page 215

Show/Hide Bookmarks
Configuration
Code Code Name Name
C043*¤ TRIP reset
C045¤ JOG enable
C046 n
set
C047 Torque limit
C049 Additional
setpoint
C050 n
set
C051 n
act
C052* Motor voltage
C054 Motor current
C056 Torque setpoint
C060* Rotor position
C061* I¼t load
C063 I
set
7-124
48XX/49XXSHB0399
Possible settings
Lenze Selection
-0- Read: no fault
Write: reset fault
-1- Read: fault
0 -0- Main setpoint (C046) active
-1- Setpoint JOG1 active
...
-15- Setpoint JOG15 active
speed -100.0 % n
-100.0 % M
-100.0 % n
at controller -180.0 % n
speed -5000 rpm
0 V
0.0 A
100 A
-100.0 % M
0...2047
0,0 %
at controller -100.0 % I
max
{0.1 %} + 100.0 % n
max max
{0.1 %} + 100.0 % M
max max
{0.1 %} + 100.0 % n
max max
{0.1 %} + 180.0 % n
max max
{1 rpm} +5000 rpm
{1 V} 600 V
{0.1 A} 100 A
{1 A} 2000 A
{0.1 %} + 100.0 % M
max max
{0.1 %} 105,0%
{0.1 %} + 100.0% I
max
Info
Only selectable via the interfaces.
Display only with terminal control.
Display only with terminal control. If the
terminal control is deactivated, the actual
terminal value will be accepted for
operation.
Display only with terminal control. If the
terminal control is deactivated, the actual
terminal value will be accepted for opera-
tion. Armature setting range: 100 % M
correspond to 100 % I (C022, C023)
max
Display: additional setpoint from terminal
Display: speed setpoint at the input of the
speed controller
Display: actual speed
Display: motor voltage V
A
Display: motor current
Display: Torque setpoint
Armature setting range: 100% M
max
correspond to 100% I (C022, C023)
max
Display of the absolute angle position of
the rotor, standardized to 2048 incr./rev.
With incremental encoder feedback,
display only after zero track pulse
occured.
Display: "I¼t load"
Starting value when switching on the
mains is always 100 % !
Display: current setpoint at current
controller input
max