Lenze 4800 Manual page 113

Show/Hide Bookmarks
Configuration
7.1.5
7.1.5.1
Code Name
C112*¤ Input
selection:
Freely
assignable
digital input
[C113*] Function
for C112
[C114*] Polarity for
C112
7-22
48XX/49XXSHB0399
Freely assignable inputs and outputs
Freely assignable digital inputs (FDI)
Change of the function assignment
Proceed as follows to assign a new function to an input:
( Select the input to be assigned under code C112.
( Select the function required under code C113.
( Select under code C114 whether the function is to be activated with a HIGH
or a LOW signal.
( Determine under code C115 whether the function is always to be switched
via terminal or, depending on the operating mode, via the correspondingly
selected interface.
Possible settings
Lenze Selection
1 -1- digital input X2/E1
-2- digital input X2/E2
...
-5- digital input X2/E5
-0- No function
-1- Enable additional T
-2- Enable JOG set-value (X4/E4, E5)
-3- TRIP reset (X2/E2)
-4- TRIP set (X2/E1)
-6- Switch-off additional setpoint (X4/E3)
-7- Switch-off I-component of the n-controller
-9- Ramp function generator stop
-10- Ramp function generator zero
-16- Motor potentiometer deactivated
-17- Motor potentiometer down
-18- Motor potentiometer up
-20- Select parameter set
-21- Load parameter set
-30- Deactivate process controller
-31- Switch-off I-component of the process
controller
-32- Set process controller evaluation to 0
-40- Enable fixed set-value
0 -0- Input HIGH active
-1- Input LOW active
Info
The digital inputs E1..E5 are freely
assignable with the functions under
C113.Each function can only be assigned
to one input.
Exceptions:
C113 = -20- : max. 2 dig. inputs
C113 = -1-, -2-, -40-: max. 4 dig. inputs
(binary coded selection of max. 1, 3, 7 or
15 additional T
Assignment of functions:
1.Select input under C112.
2.Assign function under C113.
3.Determine polarity under C114.
4.Determine priority under C115.
times
i
times or set-values).
i