Lenze 4800 Manual page 95

Show/Hide Bookmarks
Configuration
Code Name
C045¤ JOG enable
7.1.1.4
7.1.1.5
7-4
48XX/49XXSHB0399
JOG set-value enabling with control via keypad or LECOM interface
Active the JOG set-values under C045.
Possible settings
Lenze Selection
0 -0- Main set-value (C046) active
-1- Set-value JOG1 active
...
-15- Set-value JOG15 active
Master current
If the analog set-value is to be entered via X1/8 as master current, the current
setting range can be selected under C034:
( For -20mA...+20mA:
( For 4...20mA:
If range 4...20mA is selected and the current is less than 2mA, the fault "Sd5" is
indicated.
Spannungsleitwert auf Stromleitwert (Strombürde 250W) mit dem Schalter S3/1
auf der Steuerbaugruppe 4902MP umschalten:
( Master voltage/potentiometer:
(Default setting)
( Master current:
(see chapter 4.3.4)
External torque reduction
With a potentiometer, it is possible, for instance, to apply a voltage externally to
terminal 2. This voltage has a direct influence on the I
and C023.
Note!
A voltage of 0V at terminal X1/2 corresponds to I
-72-.
The corresponding speed set-value is to be applied via terminal X1/8.
Alternatively to the set-value potentiometer, the current limitation can also be under
linear influence from an external control voltage.
Info
With terminal control only display
C034 = -0-
C034 = -1- (only unipolar)
S3/1 = OFF
S3/1 = ON
max
if C005 = -1X-, -5X-, -6X- or
max
values set under C022