Lenze 4800 Manual page 122

Show/Hide Bookmarks
Code Name
C145*¤ Input
selection:
Analog
signal
Possible settings
Lenze Selection
1 -1- Input terminals X1/1, X1/2
-2- Input terminals X1/3, X1/4
-3- Input terminal X1/6
-4- Input terminal X1/8
-5- Digital frequency input X5
-6- Digital frequency input X9
-7- Resolver
-8- Motor potentiometer output
-9- Output process controller
-10- Output arithmetic block 2 output 1
-11- Fixed setpoint output
-12- Output arithmetic block 2 output 2
-13- Output dead band element output 1
-14- Output dead band elemeent output 2
-15- Output DT1 element output 1
-16- Output DT1 element output 2
-17- Output absolute value generator output 1
-18- Output absolute value generator output 2
-19- Output limiting element 1 output 1
-20- Output limiting element 1 output 2
-21- Output PT1 element output 1
-22- Output PT1 element output 2
-23- Output arithmetic block 3 output 1
-24- Output arithmetic block 3 output 2
-25- Output addition block 1 output 1
-26- Output addition block 1 output 2
-27- Output addition block 2 output 1
-28- Output addition block 2 output 2
-29- n from C382
act
-30- n from C050
set
-31- Deviation at n-controller (xw)
-32- Deviation at process controller (xw)
-33- Ramp function generator output
-34- n-controller output
-35- Square-wave generator
-36- Deviation at angle controller
-37- RFG output of process controller setpoint
-38- RFG output of process controller evaluation
-39- AIF process controller setpoint
-40- Output limiting element 2 output 1
-41- Output limiting element 2 output 2
-42- Output comparator 1
-43- Output comparator 2
Configuration
Info
The functions set under C146 can be
assigned to the input sources under
C145. Double assignment is not possible.
The function selected last is always
assigned to the input.
C007 = -5-, -6-, -9-, -20-:
The priority for these inputs can be
determined under C147.
Change of C005 (configuration):
The freely selected assignments are
overwritten with a basic assignement that
depends on the configuration.
Assignments set before must be repeated.
48XX/49XXSHB0399
7-31