Lenze 4800 Manual page 262

Show/Hide Bookmarks
Automation
Code Code Name Name
C125*¤ Baud rate
changeover
for
interface
12-2
48XX/49XXSHB0399
The operating state of the controller is indicated under C068. angezeigt.
Bit No. 15 14 13 12
Signal TRIP I QSP IMP Run n
max
( Display of the operating state of the controller.
The operating state of the controller is displayed under C069.
Bit No. 7 6
Signal Ctrl. xxx
enable
Meaning Controller
enable
( LECOM1 baud rate
The baud rate can be set under C125.
Possible settings
Lenze Selection
0 -0- 9600 baud
-1- 4800 baud
-2- 2400 baud
-3- 1200 baud
Note!
For communication via modem please contact Lenze.
( History of the reset fault
Codes C161 to C168 indicate the last 8 TRIPs stored. The fault reset last is
indicated under C161.
( LECOM1 code bank
With version 1.0 of the LECOM-A/B protocol only codes up to C255 can be
processed. The access range of this version can be changed under C249 so that
it is possible to reach higher codes. Code C249 does not exist in every code range.
Parameter in C249
0
1
2
3
4
5
6
7
For more information about serial communication with the standard interface
LECOM1 (LECOM-A/B) see the Operating Instructions LECOM-A/B.
11 10 9 8 7
= 0 Ctrl. Communication error
act
enab
le
5 4 3
RESET AUTO REMOT
Controller Terminal LECOM
reset control control
Access to code range
C000...C255
C250...C505
C500...C755
C750...C1005
C1000...C1255
C1250...C1505
C1500...C1755
C1750...C2000
6 5 4 3 2 1
Operation error
2 1 0
PCHG CALARM BALARM
Operating Communicatio Operation
mode changed n error error
Info
0