Lenze 4800 Manual page 167

Show/Hide Bookmarks
Configuration
Code Code Name Name
C260* Upper motor
potentiometer
limit
C261* Lower motor
potentiometer
limit
C262* Motor
potentiometer
acceleration
time
C263* Motor
potentiometer
deceleration
time
C264*¤ Motor
potentiometer
deactivation
function
C265*¤ Initialisation
function
Sample &
Hold
C266* Motor
potentiometer:
Operation via
keypad
C267*¤ Sample and
Hold function
7-76
48XX/49XXSHB0399
Possible settings
Lenze Selection
100% -100.0 % {0.1 %}
0 % -100.0 % {0.1 %}
10 s 1 s {1 s}
10 s 1 s {1 s}
0 -0- No function, motor potentiometer is not
changed.
-1- Down to 0%, motor potentiometer output
runs with the corresponding acceleration or
deceleration time to 0%.
-2- Down to lowest limit, motor potentiometer
output runs with the corresponding
acceleration or deceleration time to the value
under C261.
-3- Jump to 0%, motor potentiometer output
immediately changes to 0%.
-4- Jump to the lowest level, motor potentiometer
immediately changes to the value indicated
under C261.
-5- Up to the highest level, motor potentiometer
output runs with the corresponding
acceleration or deceleration to the value
indicated under C260.
0 -0- Acceptance of the saved value S&H output
accepts the value which was set before
switching the mains.
-1- Lower limit, S&H output accepts the value of
C261.
100 % {0.1 %}
0 -0- S&H for motor potentiometer output
-1- S&H für FAI signal
Info
+100.0 % C260 must be higher than C261!
+100.0 % C261 must be smaller than C260!
5000 s C262 is activated if the motor
potentiometer terminal is set to "UP"
Ref.: Change from 0...–100%
5000 s C263 is activated if the motor
potentiometer terminal is set to "DOWN"
Ref.: Change from 0...–100%
Function, which is executed when
deactivating the motor potentiometer
(terminal DEACTIVE is set).
Function which is executed when
switching on the mains.
+100 % Under C266 the motor potentiometer can
also be operated with Vand W
Display: Output value of the motor
potentiometer in % and exact control
program value.