Lenze 4800 Manual page 339

Show/Hide Bookmarks
Signals
Analog connection, 4-14
Connection of digital, 4-17
Single drives, 4-4
Slave, 7-42
Digital frequency bar, 7-42
Digital frequency cascade, 7-46
Software version, 7-128
Speed
Accuracy, 3-1
Automatic adjustment, 7-11
Controller adaptation, 7-93
Limitation, 7-89
Maximum speed, 7-14
Monitoring, 7-27
Ratio synchronism, 7-51
Set-value limitation, 7-9
Setting range, 3-1
Synchronism, 7-51
Synchronous running, 7-51
Trimming, 7-53
Speed control
With additional set-value, 7-1
With armature voltage feedback, 7-10
With incremental encoder, 7-13
With resover feedback, 7-13
With tacho feedback, 7-11
Speed controller, 7-18
Adaptation, 7-93
Speed fields, With armature voltage feed-
back, 7-10
Square-wave generator, 7-83
Standard
Considered, 1-5, 1-7
IEC 364, 2-1, 2-2
Degree of pollution, 3-3
DIN 40050, 3-3
DIN 42017/VDE 0530 part 8, 4-5
DIN 43673, 4-5
DIN VDE 0100, 1-5, 2-1
DIN VDE 0110, 1-5, 2-1, 3-3
DIN VDE 0110 VBG 4, 2-1
DIN VDE 0160, 1-5, 2-1
DIN VDE 0530/8, 4-5
DIN VDE 0558, 2-1
DIN VDE 0660 part 500, 2-1
EN 50081-2, 3-3
EN 50082-2, 1-7
EN 55011, 1-7, 3-3
EN 60097, 1-5
EN 60146, 2-1
EN 60439-1, 2-1
EN 60529, 1-5
EN 61000-4-2, 1-8, 3-3
EN 61000-4-4, 1-8, 3-3
EN 61000-4-5, 1-8, 3-3
EN 61800-3, 1-7
ENV 50140, 1-8
IEC 1000-4-3, 1-8, 3-3
IEC 22G, 3-3
IEC 249, 1-5
IEC 326, 1-5
prEN 50178, 2-1
VDE0220, 4-5
Standards, 2-1
Standstill excitation, 7-61
Supply
Separate, control electronics, 4-11
Separate, field-current bridge, 4-9
Switch-on display, 7-118
System cable, 13-10
Digital frequency coupling, 13-11
Incremental encoder, 13-11
Resolver, 13-10
System fault, 7-97, 8-4
T
Table of attributes, 7-145
Tacho
Adjustment, 7-11
Rated voltages, 4-21
Technical data, 3-1
Dimensions, 3-8
Electrical data, 3-4
General data/application conditions, 3-3
Temperature
Heat sink, 8-4
Motor, 7-101
Storage and transport, 3-3
Index
48XX/49XXSHB0399
18-9