Setting Details - Mitsubishi Electric MELSEC-Q Series User Manual

7.4.2

Setting details

Item
Select the number of master/local modules (number of modules to be
mounted on one base unit).
Number of Modules
Do not include the number of master/local modules that are set using
the dedicated instruction (G(P).RLPASET).
Set the station
information in the CC- Checking this item is not necessary for a local station or standby
Link configuration master station.
window.
Start I/O No. Set the start I/O number of a master/local module in units of 16 points.
Set the operations to be performed at an error or when the switch on a
CPU module is set to STOP.
Operation Setting
(
Select "Local Station" to use a master/local module as a local station.
Select any of the following to use a master/local module as a standby
master station. (
When only the standby master station is
Type
started up, it starts data link as a master
station.
Other than the above
*1
Master Station Data The setting is not required when a master/local module is used as a
Link Type local station or standby master station.
Description
Page 118, Section 7.4.2 (1))
Page 135, Section 8.2.5))
Operation
When select "Master Station(Duplex Function)", set the same
settings as the master station for other items. (
Section 7.3.2)
Setting
Master Station(Duplex
*1
Function)
Standby Master Station
Page 97,
CHAPTER 7 PARAMETER SETTINGS
Setting range
Varies depending on a CPU module.
( User's manual for the CPU
module used)
(Default: Blank)
–
Within the range of I/O points of the
CPU module
(Default: Blank)
–
• Local Station
• Standby Master Station
• Master Station(Duplex Function)
(Default: Master Station)
–
7
115