Mitsubishi Electric MELSEC-Q Series User Manual page 120

(1) Operation setting
Project window
button
Item
Set the name of the setting if needed.
Parameter Name This item is displayed when the setting details of the network
parameters are printed using a programming tool.
Select whether to clear or hold data input from a data link faulty
Data Link Faulty Station
Setting
station. (
Select whether to refresh or clear compulsorily output (sending) data
Case of CPU STOP
to a master station when the switch on a CPU module is set to STOP.
Setting
(
The settings are not required when the master/local module is used as
a local station or standby master station.
Select the number of occupied stations for a master/local module.
Number of Occupied
Select it only when "Local Station" or "Standby Master Station" is set to
Stations
"Type".
Select the expanded cyclic setting for a master/local module.
Select the setting only for the following cases.
Expanded Cyclic
• When "Remote Net(Ver.2 Mode)" or "Remote Net(Additional Mode)"
Setting
• When "Local Station" or "Standby Master Station" is set to "Type"
Select whether to assure the integrity of cyclic data for each slave
Block Data Assurance
per Station
station. (
118
[Parameter]
Description
Page 121, Section 7.5, Page 131, Section 8.2.3)
Page 121, Section 7.5, Page 133, Section 8.2.4)
is set to "Mode"
Page 150, Section 8.2.6 (1))
[Network Parameter] [CC-Link]
Setting range
Eight characters
(Default: Blank)
• Clear input data (not checked)
• Hold input data (checked)
(Default: Clear input data (not
checked))
• Refresh (not checked)
• Clear compulsorily (checked)
(Default: Refresh (not checked))
–
• Occupied Station 1
• Occupied Station 2
• Occupied Station 3
• Occupied Station 4
(Default: Occupied Station 1)
• Single
• Double
• Quadruple
• Octuple
(Default: Single)
• Disable setting (not checked)
• Enable setting (checked) (Default:
Disable setting (not checked))