Mitsubishi Electric MELSEC-Q Series User Manual page 408

(7) Setting and canceling a temporary error invalid station
Even if a data link error occurs in a slave station, the station is not detected as a faulty station in the master station
and local station. This setting can be configured even during data link, unlike the error invalid station setting
function.
This function is used to exchange slave stations during data link for maintenance or for other purposes.
1.
Open the "CC-Link/CC-Link/LT Diagnostics" window.
[Diagnostics]
2.
In "Module Setting", select "CC-Link". Then select a master station to be monitored in "Module
No." or "I/O Address".
3.
Click the
4.
Click the
5.
Select the line of the station where the temporary error invalid station setting is configured or
canceled. Then click the
● If the
● While configuring the setting, do not write data to the buffer memory areas (buffer memory addresses: 5E0
603 to 607
H
● Do not configure or cancel the temporary error invalid station setting using a program and other peripherals at the same
time. The temporary error invalid station setting may not be normally configured or cancelled.
406
[CC-Link/CC-Link/LT Diagnostics]
button.
button.
button cannot be clicked, check that the master station has been selected in "Module Setting".
).
H
button.
, 5E4 , and
H H