Mitsubishi Electric MELSEC-Q Series User Manual page 100

Item
Select "Master Station".
To configure the system that switches the control to the standby
master station if the master station goes down, set as follows.
(
When a failed master station becomes
Type
normal again, it does not return as a
standby master station.
• When a failed master station becomes
normal again, it returns as a standby
master station.
• When only the standby master station
is started up, it starts data link as a
master station.
Master Station Data "PLC Parameter Auto Start" is displayed. (The setting is not
Link Type required.)
Select the mode of a master/local module. (
Section 3.6.2 to Page 55, Section 3.6.6)
Mode
If the mode is selected in the CC-Link configuration window for
the station information setting, the mode selected in the CC-Link
configuration window is automatically set.
Set the number of modules to be connected to a slave station.
(including a reserved station)
Total Module
If "Set the station information in the CC-Link configuration
Connected
window" is checked, the setting is automatically input by
configuring "Station Information Setting".
98
Description
Page 135, Section 8.2.5)
Operation Setting
• Master Station
• Master Station(Duplex Function)
Master Station
• Master station (Extension Base)
(Default: Master Station)
Master Station(Duplex
Function)
• Remote Net(Ver.1 Mode)
Page 43,
• Remote Net(Ver.2 Mode)
• Remote Net(Additional Mode)
• Remote I/O Net Mode
• Offline
(Default: Remote Net(Ver.1 Mode))
1 to 64 (Default: 64)
Setting range
*2
-