Table of Contents
Advertisement
7.3.2
Setting details
Item
Select the number of the L series master/local
modules that are set using a programming tool.
Number of Modules
Do not include the number of the L series master/local
modules that are set using the dedicated instruction
(G(P).RLPASET).
Select it when graphically configuring "Station
Set the station
Information Setting" by referring to the network map
information in the CC-
Link configuration
display area. (Refer to
window
(2).)
Set the start I/O number of a master station in units of
Start I/O No.
16 points.
Set the operations to be performed upon an error or
when the switch on a CPU module is set to STOP.
Operation Setting
(Refer to
Description
Page 83, Section 7.3.2
Page 82, Section 7.3.2 (1))
CHAPTER 7 PARAMETER SETTINGS
Setting range
Varies depending on a CPU module. (Refer to
Page 72, Section 7.1)
(Default: Blank)
• The station information is not set in the CC-Link
configuration window. (The checkbox: Not checked)
• The station information is set in the CC-Link
configuration window. (The checkbox: Checked)
(Default: The station information is not set in the
CC-Link configuration window. (The checkbox: Not
checked))
Within the range of I/O points of the CPU module
(Default: Blank)
7
77
Advertisement
Table of Contents
Troubleshooting
