Mitsubishi Electric MELSEC-Q Series User Manual page 217

● Set the switch 3 and switch 4 within the range listed in the above table. If a value outside the range is set or no value is
set, the G(P).RLPASET instruction ends abnormally. Note that CC-Link is automatically started up for the master/local
module with the smallest start I/O number instead. (
● Keep the switches 1, 2, and 5 blank. If any values are set, the normal operation is not guaranteed.
4.
Click the
5.
Create the following program.
Refresh of SB/SW
Parameter setting
G(P).RLPASET instruction
Control data
Slave station setting data
Reserved station specification data
Error invalid station specification data
Communication and automatic update buffer assignment data
*1 Set the station number in hexadecimal. (Example) Set 14
Page 159, Section 8.3.3)
button to terminate the setting.
for station No. 20.
H
CHAPTER 9 DEDICATED INSTRUCTIONS
Data in SB0020 to SB01FF are read
to SB0020 to SB01FF.
Data in SW0020 to SW01FF are
read to SW0020 to SW01FF.
Instruct to set parameters
Clear completion status.
All setting data: Valid
Total module connected: 3
Retry count: 3 times
Automatic reconnection station
count: 1
Operation specification when CPU is
down: Stop
Scan mode setting:
Delay time setting: 0
First: Local station, occupies
1 station, station
number 1 *1
Second: Remote I/O station,
occupies 1 station,
station number 2
Remote I/O station,
Third:
occupies 1 station,
station number 3
Reserved station specification:
station number 3
Error invalid station specification:
station number 2
First (station number 1) local station
Send buffer: 100 word
First (station number 1) local station
Receive buffer: 100 word
First (station number 1) local station
Automatic update buffer: 0 word
(To the next page)
9
215