Mitsubishi Electric MELSEC-Q Series User Manual page 25

No. Name
Sets the transmission speed and mode of the master/local module. (Default: 0)
Set the same value of the transmission speed for all stations.
Online
Line test (
Transmission
3) speed/mode setting
switch
Hardware test (
Setting not allowed
Used to connect a CC-Link dedicated cable. (
The SLD and FG terminals are connected inside the module.
4) Terminal block
Because a two-piece terminal block is used, the module can be replaced without disconnecting the signal
line to the terminal block.
Before installing or removing the terminal block, power off the module.
Serial number
5) Indicates the serial number on the rating plate.
display
The settings of the station number setting switches and the transmission speed/mode setting switch are enabled by resetting
the CPU module or powering off and on the system.
Mode
Page 86, Section 6.5.1)
• When the station number setting switches
are set at 0
Line test 1
• When the station number setting switches
are set at 1 to 64
Line test 2
Page 324, Section 11.5)
Application
Transmission speed
setting
Transmission speed: 156kbps
Transmission speed: 625kbps
Transmission speed: 2.5Mbps
Transmission speed: 5Mbps
Transmission speed: 10Mbps
Transmission speed: 156kbps
Transmission speed: 625kbps
Transmission speed: 2.5Mbps
Transmission speed: 5Mbps
Transmission speed: 10Mbps
Transmission speed: 156kbps
Transmission speed: 625kbps
Transmission speed: 2.5Mbps
Transmission speed: 5Mbps
Transmission speed: 10Mbps
Page 77, Section 6.2.2)
CHAPTER 2 PART NAMES
Switch number
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
23
2