Mitsubishi Electric MELSEC-Q Series User Manual page 121

(2) Interrupt Settings
Project window
button
1.
In "Interrupt Settings" window, set the conditions on which a master/local module issues the
interrupt to a CPU module.
2.
Click the
Item
Input Format Select the input format of "Word Device Setting Value".
Device Code
Set the device for the interrupt condition.
Device No.
Detection Method
Select the timing of the interrupt detection for the device set to "Device
Code" and "Device No.".
Interrupt Condition
Word Device Setting Set the word device value for the interrupt condition if RWr or SW is
Value set to "Device Code".
Channel
The setting is not required for a master/local module.
No./Connection No.
Set the interrupt (SI) No. used for the interrupt pointer setting of the
PLC parameter.
Interrupt (SI) No. The interrupt (SI) No. is the control number on the master/local
module side to issue a request for the interrupt from a master/local
module to a CPU module. (This is not the device used for an actual
program.)
Only one interrupt condition can be set for one interrupt program.
[Parameter] [Network Parameter]
button and close the setting window.
Description
CHAPTER 7 PARAMETER SETTINGS
[CC-Link]
Setting range
• DEC
• HEX
(Default: DEC)
Refer to the following table.
7
119