Chapter 7 Parameter Settings; Parameter Setting Method - Mitsubishi Electric MELSEC-Q Series User Manual

CHAPTER 7
For CC-Link, set parameters both for a master station and a slave station.
For a master station, set the information about a slave station to be connected to a CC-Link system.
For a slave station, set the station number of the slave station. (
This chapter describes how to set the parameters for a master/local module.
7.1

Parameter Setting Method

Parameters for a master/local module can be set by using a programming tool or a dedicated instruction. Select the
setting method depending on the application.
Item
Parameter settings by using a
programming tool
Parameter settings by using
the dedicated instruction
(G(P).RLPASET instruction)
PARAMETER SETTINGS
Application
Use a programming tool for the following cases.
• To set parameters on a window in a simply way, without creating program
• To transfer data automatically from RX, RY, RWr, RWw, SB, and SW in a
master/local module to a device in a CPU module
Use the dedicated instruction for the following cases.
• To connect nine or more master/local modules to one programmable
controller system
• To change the parameter settings while a CPU module is set to RUN

CHAPTER 7 PARAMETER SETTINGS

Manual for the slave station used)
Page 96, Section 7.3
Page 114, Section 7.4
Page 205, Section 9.8
Reference
7
93