Mitsubishi Electric MELSEC-Q Series User Manual page 97

Item
Standby Master Station No.
PLC Down Select
Scan Mode Setting
Delay Time Setting
Station Information Setting
Set the station information in the CC-Link
configuration window.
Remote Device Station Initial Setting
Interrupt Settings
Necessity of a setting
Local station,
Master station standby
master station
×
×
×
×
×
×
×
CHAPTER 7 PARAMETER SETTINGS
Remark
• It is automatically input when the standby
master station is set in the CC-Link
configuration window.
• The setting is not required when "Remote I/O
Net Mode" is set to "Mode".
–
The settings are not required when "Remote I/O
Net Mode" is set to "Mode".
Select it when graphically configuring "Station
Information Setting" by referring to the network
map display area. (for GX Works2 only)
The setting is not required when "Remote I/O
Net Mode" is set to "Mode".
–
7
95