Set Up Smv Automatic Execution - Emerson Micro Motion 5700 Configuration And Use Manual

Table 12-1:
Code
Other
12.1.3

Set up SMV automatic execution

You can set up and run a single test at a user-defined future time. You can also set up and
run tests automatically on a regular schedule.
Automatic execution of SMV is managed from the transmitter. You do not need a
connection from an external configuration tool.
Tip
The time between test runs must be between 1 and 1000 hours. The time to the first test run can be
any positive floating number.
Important
Only the 20 most recent SMV results are stored. For SMV Basic versions, the last automatic execution
result can be viewed, while all 20 results can be viewed with SMV licensed. To view or chart these
results using an external tool, you must upload them from the transmitter.
•
•
•
Set up SMV automatic execution using the display
1.
2.
3.
4.
Configuration and Use Manual
SMV abort codes
Description
General abort
Set up SMV automatic execution using the display
Set up SMV automatic execution using ProLink III
Set up SMV automatic execution using a web browser
Choose Menu > Service Tools > Verification & Calibration > Smart Meter Verification
> Schedule SMV.
To schedule a single test:
a. Set Hours to 1st Run to the number of hours to elapse before the test is run.
b. Set Hours Between to 0.
To schedule a recurring execution:
a. Set Specify Time Until Next Run to the number of days, hours, and minutes to
elapse before the first test is run.
b. Set Specify Time Between Recurring Runs to the number of days, hours, and
minutes to elapse between runs.
To disable scheduled execution:
a. Set Specify Time Until Next Run to 0 days, 0 hours, and 0 minutes.
b. Set Specify Time Between Recurring Runs to 0 days, 0 hours, and 0 minutes.
(continued)
Recommended actions
Repeat the test. If the test aborts again, contact
customer service.
Measurement support
167