Configure Frequency Output Source - Emerson Micro Motion 5700 Configuration And Use Manual

8.5.1

Configure Frequency Output Source

Display
ProLink III
Web browser
Overview
Frequency Output Source specifies the process variable that is reported by the frequency
output.
Prerequisites
•
•
Procedure
Set Frequency Output Source as desired.
Defaults:
• Frequency Output 1: Mass Flow Rate
Postrequisites
If you change the configuration of Frequency Output Source, verify the frequency output
scaling. The transmitter automatically loads the most recent values for the scaling
parameters, and they may not be appropriate for your application.
Related information
Options for Frequency Output Source
The transmitter provides a basic set of options for Frequency Output Source, plus several
application-specific options. Different communications tools may use different labels for
the options.
Process variable
Standard
Mass flow rate
Volume flow rate
Configuration and Use Manual
Menu > Configuration > Inputs/Outputs > Channel C > I/O Type > Frequency Output
Device Tools > Configuration > I/O > Channels > Channel C > Frequency Output
Configuration > Inputs/Outputs > Channel C > Frequency Output
If you plan to configure the output to report volume flow, ensure that you have set
Volume Flow Type as desired: Liquid or Gas Standard Volume.
If you plan to configure an output to report a concentration measurement process
variable, ensure that the concentration measurement application is configured so
that the desired variable is available.
Configure Frequency Output Scaling
Display
Mass Flow Rate
Volume Flow Rate
Integrate the meter with the control system
Label
ProLink III
Mass Flow Rate
Volume Flow Rate
Web browser
Mass Flow Rate
Volume Flow Rate
129