Emerson Micro Motion 5700 Configuration And Use Manual page 258

Using the transmitter display
Figure A-2:
Table A-1:
Status LED condition
Solid green
Solid yellow
Solid red
Flashing yellow (1 Hz)
Table A-2:
Network status LED condition Ethernet network status
Flashing green
Solid green
Flashing red
Solid red
LCD panel
In normal operation, the LCD panel shows the current value of the display variables, and
their measurement units.
250
Model 5700 transmitter status LEDs
Status LED and device status
Device status
No alerts are active.
One or more alerts are active with Alert Severity = Out of Specifica-
tion, Maintenance Required, or Function Check.
One or more alerts are active with Alert Severity = Failure.
The Function Check in Progress alert is active.
Network status LED and Ethernet network connection status
No connections made with primary protocol host.
Connection made with primary protocol host.
Connection from primary protocol host has timed out.
Address Conflict Detection (ACD) algorithm has detected a dupli-
cate IP address.
Micro Motion Model 5700 with Ethernet Transmitters