Configure Volume Flow Measurement For Liquid Applications; Configure Volume Flow Type For Liquid Applications - Emerson Micro Motion 5700 Configuration And Use Manual

Configure process measurement
•
•
•
•
Result:
•
•
4.3 Configure volume flow measurement for liquid
applications
The volume flow measurement parameters control how liquid volume flow is measured
and reported. The volume total and volume inventory are derived from volume flow data.
Restriction
You cannot implement both liquid volume flow and gas standard volume flow at the same time.
Choose one or the other.
•
•
•
4.3.1

Configure Volume Flow Type for liquid applications

Display
ProLink III
Web browser
Overview
Volume Flow Type controls whether liquid or gas standard volume flow measurement will
be used.
36
mA Output Process Variable: Mass Flow Rate
Frequency Output Process Variable: Mass Flow Rate
mA Output Cutoff: 15 g/sec
Mass Flow Cutoff: 10 g/sec
If the mass flow rate drops below 15 g/sec but not below 10 g/sec:
- The mA output will report zero flow.
- The frequency output will report the actual flow rate, and the actual flow rate will
be used in all internal processing.
If the mass flow rate drops below 10 g/sec, both outputs will report zero flow, and 0
will be used in all internal processing.
Configure Volume Flow Type for liquid applications
Configure Volume Flow Measurement Unit for liquid applications
Configure Volume Flow Cutoff
Menu > Configuration > Process Measurement > Flow Variables > Volume Flow Settings >
Flow Type > Liquid
Device Tools > Configuration > Process Measurement > Flow > Volume Flow Type > Liq-
uid Volume
Configuration > Process Measurement > Flow Variables > Volume Flow Type > Liquid Vol-
ume
(Section 4.3.1)
(Section 4.3.3)
Micro Motion Model 5700 with Ethernet Transmitters
(Section 4.3.2)