Configure Process Measurement Applications; Set Up The Api Referral Application; Set Up The Api Referral Application Using The Display - Emerson Micro Motion 5700 Configuration And Use Manual

5 Configure process measurement
applications
Topics covered in this chapter:
•
•
5.1

Set up the API referral application

The API referral application corrects line density to reference temperature and reference
pressure according to American Petroleum Institute (API) standards. The resulting process
variable is referred density.
Restriction
The API referral application is not compatible with the following applications:
•
•
•
•
•
•
5.1.1

Set up the API referral application using the display

This section guides you through the tasks required to set up and implement the API
referral application.
1.
2.
3.
Enable the API referral application using the display
The API referral application must be enabled before you can perform any setup. If the API
referral application was enabled at the factory, you do not need to enable it now.
Prerequisites
The API referral application must be licensed on your transmitter.
Procedure
1.
Configuration and Use Manual
Set up the API referral application
Set up concentration measurement
Gas Standard Volume Measurement (GSV)
Concentration Measurement
Set up the API referral application using the display
Set up the API referral application using ProLink III
API tables supported by the API referral application
Process variables from the API referral application
Enable the API referral application using the display
Configure API referral using the display
Set up temperature and pressure data for API referral using the display
Choose Menu > Configuration > Process Measurement.

Configure process measurement applications

(Section 5.1.1)
(Section 5.1.2)
(Section 5.1.3)
(Section 5.1.4)
55