Turn On And Turn Off Automatic Scrolling Through The Display Variables - Emerson Micro Motion 5700 Configuration And Use Manual

Configure device options and preferences
The display precision does not affect the actual value of the variable, the value used in
calculations, or the value reported via outputs or digital communications.
Procedure
1.
2.
7.1.4 Turn on and turn off automatic scrolling through the
display variables
Display
ProLink III
Web browser
Overview
You can configure the display to automatically scroll through the list of display variables or
to show a single display variable until the operator activates Scroll. If Auto Scroll is turned
on, you can configure the number of seconds that each display variable will be shown.
Procedure
1.
102
Select a process variable or a diagnostic variable.
You can configure the precision for all variables, whether or not they are assigned as
display variables. The configured precision will be stored and used when applicable.
Set Number of Decimal Places to the number of decimal places to be used when this
variable is shown on the display.
• Default:
- Temperature variables: 2
- All other variables: 4
• Range: 0 to 5
Tip
The lower the precision, the greater the change must be for it to be reflected on the display.
Do not set Number of Decimal Places too low to be useful.
Menu > Configuration > Display Settings > Auto Scroll
Device Tools > Configuration > Transmitter Display > General > Auto Scroll
Configuration > Transmitter Display > General > Auto Scroll
Turn on or turn off Auto Scroll as desired.
Option Description
On The display automatically shows each display variable for the number of seconds
specified by Scroll Rate, then shows the next display variable. The operator can
move to the next display variable at any time by activating Scroll.
Off The display shows Display Variable 1 and does not scroll automatically. The opera-
tor can move to the next display variable at any time by activating Scroll.
Micro Motion Model 5700 with Ethernet Transmitters