Table 15-3:
Status alerts, causes, and recommendations
Alert
Configuration and Use Manual
Name
Cause
[019] RAM Error
There is a ROM checksum
(Transmitter)
mismatch in the transmit-
ter or the RAM address lo-
cation cannot be written
in the transmitter.
This alert will not clear un-
til you reboot or power-
cycle the transmitter.
(continued)
Conditions
Recommended actions
•
Ensure that all wiring compartment
covers are installed correctly.
•
Ensure that all transmitter wiring
meets specifications and that all cable
shields are properly terminated.
•
Verify that the drain wires from the 4-
wire cable are properly landed.
Micro Motion recommends landing
the drain wires outside the core pro-
cessor housing. If the drain wires are
landed inside the core processor hous-
ing, they must be covered by the foil
shield for their full length, until they
land under the ground screw.
•
Ensure that all meter components are
grounded properly.
•
Evaluate the environment for sources
of high electromagnetic interference
(EMI) and relocate the transmitter or
wiring as necessary.
•
Reboot or power-cycle the transmitter
to see if the alert clears.
•
If the alert persists, replace the trans-
mitter.
Troubleshooting
207